Download Filament profiles
For the most accurate results, we recommend using our Filament Profiles, which contain printer- and slicer-specific settings for PLA woodFill filament developed and tested by the colorFabb team.
General Print settings
If you're looking for general print settings, drying guidelines or technical data for PLA woodFill filament, visit our Print Support page.
|
Advised 3D printing temperature 195-220C* |
|
Advised 3d print speed 40 - 100 mm/s |
|
Advised Heated bed 50-60C |
|
Cooling fan - |
TIP! For stronger prints and better reliability you can increase flow rate with about 0-10%. This will cause the filament to keep going through the hot zone at a steady pace.
Please note that due to different batches of wood fibers slight color differences can occur between batches. This is the nature of… well, nature.
For more info check out our colorFabb website